Then power on the problematic system and once powered on, check if the printer is clear of the error state.Now power on the printer and once it is properly powered on.Then power on the router and let it stabilize.Afterward, connect back all the power and network cables to the devices.Also, make sure all the printer parts (including cartridges or toners) are properly connected. Now wait for 5 minutes and in the meantime, check if the printer is clear of any debris or jammed paper.Then remove the network cables from the back of the router and PC.Now, unplug the power cable of all the devices and disconnect all the devices from each other.Power off your system, router, and printer.If so, check the Canon website to understand the lighting pattern and troubleshoot accordingly e.g., if the B and C lights on the printer are full-on but not blinking, then you may have to replace the print cartridges. Here, performing a cold restart of the printer, router, and system may clear the glitch and thus solve the problem.īut before moving to that route, check if any lights are blinking on the printer. Perform a Cold Restart of the Printer, Router, and SystemĪ temporary communication glitch between the printer and system may result in the printer error state issue. if the LAN or Wi-Fi modules of the printer have gone bad, then the printer may fail to communicate with the system and cause the error state message. Hardware Issue: The issue under discussion could be a result of a hardware problem with the printer e.g.
#Canon mx430 series printer in error state driver
Corrupt Installation of the Canon Printer Driver: If the Canon printer’s driver has become corrupt (e.g., due to a sudden power failure), then the printer might show the error state issue.Corrupt or Incompatible Router Firmware: If the router’s firmware is corrupt or the router was recently changed, then the printer and system may fail to communicate with each other, resulting in the printer issue at hand.Interference from Firewall or Antivirus: If a security product of your system is hindering the printer’s driver access to an essential system resource (like print spooler), then it may cause the error state issue.